Manual installation (Windows XP)
Important: Please install the KManager software before plugging in the ECU
1. Plug the USB cable into the ECU and laptop. The ECU does not need to be in the vehicle at this point. When you plug in the USB cable the following message should be displayed on the Windows Taskbar.
2. Windows will automatically run the Found New Hardware Wizard. Windows will prompt for USB drivers. Click on Install from a list of specific location.
3. Windows will prompt for USB drivers. Enter the path to the KManager software (normally this is C:\Program Files\KManager.
4. Windows will warn that the USB drivers have not passed Windows Logo testing. Click on Continue Anyway.
5. Windows will copy drivers, and shortly the following message will be displayed on the Taskbar.
The USB drivers are now installed.
Manual installation (Windows Vista)
1. Plug the USB cable into the ECU and laptop. The ECU does not need to be in the vehicle at this point. When you plug in the USB cable the following message should be displayed. Click on 'Locate and install driver software'.
2. |
Vista starts to search for drivers. |
3. |
Vista requests a location for the drivers. Select 'I don't have the disc' (even if you do). |
4. |
Select 'Browse my computer'. |
5. |
Enter the install location of KManager (normally C:\Program Files\KManager). |
6. |
Vista will start to install the drivers. |
7. |
Vista may warn (depending on security settings) that the drivers are unsigned. Select 'Install this driver software anyway'. |
8. |
The drivers will be installed, and then a message shown to tell you that the drivers have installed. Click on Close. |
9. |
A message is displayed to tell you that the hardware is intalled. Click on Close. |
The USB drivers are now installed.